Radial
Fragrance for Women
(SOLD) P&W R1340 wiring loom
Pratt & Whitney R-1340 wiring harness, off a CAC wirraway but will fit T-6 Texan etc
stamped Breeze BBB
$350
stamped Breeze BBB
$350
Armstrong Siddeley Cheetah radial engines
Armstrong Siddeley Cheetah engines
Engine #1 This is an incomplete Armstrong Siddeley Cheetah engine that was used on an RAAF Avro Anson, it has no crank, but it has mags, case, cyclinders, heads, one new old stock cylinder and various other small parts.
Engine #2 This is an incomplete Armstrong Siddeley Cheetah engine that was used on an RAAF Avro Anson, it has a case, crank, rods, one cylinder head and some spares
Out of the two you may be able to get an engine running or build as a static display.
$1350
Will ship worldwide
Engine #1 This is an incomplete Armstrong Siddeley Cheetah engine that was used on an RAAF Avro Anson, it has no crank, but it has mags, case, cyclinders, heads, one new old stock cylinder and various other small parts.
Engine #2 This is an incomplete Armstrong Siddeley Cheetah engine that was used on an RAAF Avro Anson, it has a case, crank, rods, one cylinder head and some spares
Out of the two you may be able to get an engine running or build as a static display.
$1350
Will ship worldwide
(SOLD) Continental W-670-9A Engine
Continental W-670-9A / R-670 engine as used on many aircraft and vehicles during WW2 such as the Boeing Stearman.
This version is from the US navy and was made to go into a Landing Vehicle Tracked but will also go into an M3 Stuart tank.
On original LVT engine cradle, very good running condition, complete, ready to install, engine acquired 45 years ago in supposed NOS condition, only been run a few times over that time always pre oiled prior, Stuart oil tank not included, $20,000 USD.
World wide shippingis available, contact us for a quote.
This version is from the US navy and was made to go into a Landing Vehicle Tracked but will also go into an M3 Stuart tank.
On original LVT engine cradle, very good running condition, complete, ready to install, engine acquired 45 years ago in supposed NOS condition, only been run a few times over that time always pre oiled prior, Stuart oil tank not included, $20,000 USD.
World wide shippingis available, contact us for a quote.
(SOLD) Guiberson diesel radial tank engine (Guiberson T1020)
Guiberson diesel radial tank engine as used in various WW2 tanks and landing craft, the engine is in good condition and comes on an engine stand but has not been run.
Contact us for a shipping quote.
NOS jack and Heinz JH4 starter
New old stock jack and Heinz starter
model JH4ER12
Suit P&W R2600, R2800 etc, F4U corsair, A-26, B-25 etc
$750
model JH4ER12
Suit P&W R2600, R2800 etc, F4U corsair, A-26, B-25 etc
$750
P&W R-1830 magnetos
Bendix Scintilla SF14 LN-3 magnetos, 3 available in original transport stands
likely overhauled but have been in storage for 40 years so fair condition/tbo
Used on C-47/DC-3 and many others
$350/each
likely overhauled but have been in storage for 40 years so fair condition/tbo
Used on C-47/DC-3 and many others
$350/each
(SOLD) P&W R-1830 engine
Pratt & Whitney R1830-92 1200hp twin wasp engine.
missing logbook but has been inspected by an engine shop and found to be in good condition.
EX-SAAF DC-3 /C-47, likely removed when they converted to turboprops.
The nose case has been removed and the reduction gear and front case bearings were found to be in good condition with no signs of damage and no metal found.
It has had cylinders 7 and 8 removed to inspect the master rod bearings, no damage to either front or rear master rod bearing could be seen, and no metal was found, the master rods had a light coating of baked on oil, which indicated that the engine is low time.
The center crankcase is the heavy duty version, typical of the gold engines from South Africa, all cylinders appear to be standard bore.
The rear case was removed to inspect the rear supercharger bearing which is the one most likely to fail, the bearing was intact, and no metal was found.
$6500
World wide shipping available
missing logbook but has been inspected by an engine shop and found to be in good condition.
EX-SAAF DC-3 /C-47, likely removed when they converted to turboprops.
The nose case has been removed and the reduction gear and front case bearings were found to be in good condition with no signs of damage and no metal found.
It has had cylinders 7 and 8 removed to inspect the master rod bearings, no damage to either front or rear master rod bearing could be seen, and no metal was found, the master rods had a light coating of baked on oil, which indicated that the engine is low time.
The center crankcase is the heavy duty version, typical of the gold engines from South Africa, all cylinders appear to be standard bore.
The rear case was removed to inspect the rear supercharger bearing which is the one most likely to fail, the bearing was intact, and no metal was found.
$6500
World wide shipping available
(SOLD) Continental R975-EC2 tank radial engine
Continental R975-EC2 Radial engine, overhauled and rebuilt bottom end.
Just requires top end assembled which is supplied with engine.
Comes with Magneto’s, Carby, Starter, induction.
email for more info/photos
This engine was used on M3 Lee, M4 Sherman M7 Priest, M18 Hellcat tanks, Kangaroo APCs etc it is the vehicle adaption of the Wright Whirlwind aircraft engine.
$7500, worldwide shipping available
Just requires top end assembled which is supplied with engine.
Comes with Magneto’s, Carby, Starter, induction.
email for more info/photos
This engine was used on M3 Lee, M4 Sherman M7 Priest, M18 Hellcat tanks, Kangaroo APCs etc it is the vehicle adaption of the Wright Whirlwind aircraft engine.
$7500, worldwide shipping available
rebuilt bottom end
Cutaway stromberg carburettor
Bendix Stromberg cut away carb
great display or training tool
Suits R-975 / R-985 maybe others
$700
great display or training tool
Suits R-975 / R-985 maybe others
$700
Hamilton standard governor 4G8G49M
Hamilton Standard constant speed control
model 4G8G49M
good original condition
Suit A-26, R-2800 etc
$300
model 4G8G49M
good original condition
Suit A-26, R-2800 etc
$300
R985, R1340 Magneto, cutaway museum quality display
Pratt Whitney R985, R1340 Radial Magneto, cutaway museum quality display
Suit museum, trade school etc
very good condition, $550 US
Suit museum, trade school etc
very good condition, $550 US
P&W R-985 cutaway display engine
This is a Pratt & Whitney R-985 aircraft cutaway display engine, ideal for a museum or mechanical/trade school.
It is designed to run off a small electric motor that has been placed inside the engine starter motor to slowly rotate the engine.
It is currently running on Australian 240v mains but can be converted to run anywhere fairly easily.
First run in 1929 this engine was used on many pre war and post war aircraft.
$9500
World wide shipping is available.
It is designed to run off a small electric motor that has been placed inside the engine starter motor to slowly rotate the engine.
It is currently running on Australian 240v mains but can be converted to run anywhere fairly easily.
First run in 1929 this engine was used on many pre war and post war aircraft.
$9500
World wide shipping is available.
R-2800 Dynafocal Engine Vibration absorbers (SOLD)
R-2800 Dynafocal Engine Vibration absorbers
P/N MR-36-2B, 6 available, NOS, suit R2800, F6F, F4U, A-26, F7F, F8F, P-47 etc
$850/lot
P/N MR-36-2B, 6 available, NOS, suit R2800, F6F, F4U, A-26, F7F, F8F, P-47 etc
$850/lot
Vultee A-35 Vengence engine mount
Vultee A-35 Vengence engine mount very good condition, ex-raaf, could be made airworthy
heavy! contact for shipping
CAC Winjeel oil cooler
Ex RAAF CAC Winjeel oil cooler
Looks serviceable, with mount
Looks serviceable, with mount
- 1